DUMP TRAILER Power UNIT- SINGLE ACTING
This electrical power unit has a power up gravity down circuit. Commence the motor to lengthen the cylinder and activate the solenoid valve to retract the circuit. Guide override to solenoid valve may be provided if required. Also a strain compen sated flow control might be additional towards the circuit to manage the descent pace from the cylinder.
Remark: Please consult our revenue engineer for your different pump displacement, motor power or tank capability.
1. This energy unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
2. Clean every one of the hydraulic elements concerned in advance of installation of the energy unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst,which should really also be clean and free of charge of impurities.N46 hydraulic oil is suggested.
four. The energy unit must be mounted horizontally.
five. Check the oil degree during the tank following the initial operating with the electrical power unit.
6. Oil transforming is needed immediately after the preliminary one hundred operation hrs, afterwards once just about every 3000 hours.
DUMP TRAILER Energy UNIT-DOUBLE ACTING
This power unit has a power up electrical power down circuit with load holding on each A & B ports. A pressure compensatred flow management may be added to circuit to regulate the decent speed of your cylinder.
1. This power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean every one of the hydraulic parts concerned just before set up of the energy unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst, which should also be clean and no cost of impurities. N46 hydraulic oil is advised.
four. The energy unit ought to be mounted horizontally.
five. Check the oil degree within the tank just after the original running from the electrical power unit.
6. Oil modifying is needed after the preliminary one hundred operation hours, afterwards when every 3000 hrs.