Power UNITS FOR LIFT TABLE 1
Standard Description
This energy unit is intended exclusively to the small lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit has become extensively applied within the market of logistic gadgets for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled by the solenoid valve with all the velocity managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This energy unit is created exclusively for that medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as 
well as velocity managed from the adjustable needle valve. Once the lift rises to a large positoin, however the power supply is minimize, the reducing motion is managed by the guide override perform.
Energy UNITS FOR LIFT TABLE three
Standard Description
This power unit is created solely for the significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and the velocity controlled by a strain compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is developed solely for the massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve and also the pace controlled from the adjustable needle valve. When the lift rises to a substantial positoin, but the energy provide is cut, the reducing motion is managed from the manual override function.
Particular Notes
1. This energy unit is of S3 duty cycle, which could only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned prior to installation of the energy unit.
3. Viscosity with the oil shoud be 15~46 cst,which should also be clean and no cost of impurities.N46 hydraulic oil is advisable.
4. Oil altering is needed following the preliminary one hundred operation hrs,afterwards once each and every 3000 hrs.
five. The energy unit proven is built to be mounted vertically.
