SMR Gearbox Installation
Satisfactory functionality will depend on right set up. lubrication and maintenance. as a result it’s important the directions while in the installation and upkeep leaflet. provided with just about every gearbox. are followed thoroughly. a number of the significant aspects of belt and torque-arm installation are listed under.
one. Install pulley on gearbox input shaft as close on the reducer possible, and mount reducer on driven shaft as shut to bearing as practical. failure to perform this will lead to extra loads while in the input shaft bearings and output bearings and could induce their premature failure.
two. Install motor and wedge belt drive with the belt pull at about 90° to your center line between driven and input 
shafts. this will permit tensioning on the wedge belt drive together with the torque arm which should preferably be in tension. if output hub runs anti-clockwise. torque arm really should be positioned the best.
3. lnstall torque-arm fulcrum on a rigid help to ensure the torque-arm will probably be at around correct angles to your center line with the driven shaft plus the torque arm situation bolt. be certain there is certainly enough get up in the turnbuckle for belt stress adjustment.
Hold shut.
Bell drive can be found in any practical postion. if the torque arm will be to be utilized to tighten the belts, the drive ought to be at about tight angle to your line involving the input and output shafts.
Bell drive may be found on the ideal if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite course to that proven while in the illustration.
Torque arm and belt take up.
Torque arm might be mounted for the right if preferred.
